* *short* : attribute configured with this option will always printed by default
-* *long* : attriuted configured with this option will get printed only when
+* *long* : attribute configured with this option will get printed only when
user inputs the default parameter *long*, defined in *default_parameters*
section. So to print all attributes of a command, user will input parameter:
5. Profile information is persisted, so when you disconnect and connect again the CLI console,
you can start use the same profile again.
-NOTE: Use the directive 'set' for setting the values for parameters and 'unset' for reseting the values.
+NOTE: Use the directive 'set' for setting the values for parameters and 'unset' for resetting the values.
In Beijing release, new default profile named as 'onap-beijing' is delivered with all default ONAP service
credentials. so user could use this profile to avoid setting the credentials every time.
-------------------
Following documents provide the usage for each commands supported in different releases.
-NOTE: Command marked with EXPERIMENTAL is only for testing purpose. Its not recommeded to use in production environment
+NOTE: Command marked with EXPERIMENTAL is only for testing purpose. Its not recommended to use in production environment
.. toctree::
:maxdepth: 1