2 # ============LICENSE_START=======================================================
4 # ================================================================================
5 # Copyright (C) 2017 AT&T Intellectual Property. All rights reserved.
6 # ================================================================================
7 # Copyright (C) 2017 Amdocs
8 # =============================================================================
9 # Licensed under the Apache License, Version 2.0 (the "License");
10 # you may not use this file except in compliance with the License.
11 # You may obtain a copy of the License at
13 # http://www.apache.org/licenses/LICENSE-2.0
15 # Unless required by applicable law or agreed to in writing, software
16 # distributed under the License is distributed on an "AS IS" BASIS,
17 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
18 # See the License for the specific language governing permissions and
19 # limitations under the License.
21 # ECOMP is a trademark and service mark of AT&T Intellectual Property.
22 # ============LICENSE_END=========================================================
26 # This property file supplies the configuration defaults for the APP-C controller
28 # Default values are supplied so that all defined properties have well-known values and are
29 # valid even if a configuration file is not supplied. This is done to ensure that a runnable,
30 # stable, and defined configuration exists at all times. The reason the defaults are supplied
31 # via this property file and not in the code is so that the properties can be changed
32 # easily if needed in the future. Use of the "getProperty(name, default)" method is
33 # discouraged because if the default value needs to be changed, everywhere in the code it
34 # is used would have to be changed. By loading the defaults in this property file, all
35 # values can be defined in one place and support is easier. This does mean that all
36 # properties that are defined must have a default value supplied here. Which also means
37 # this file documents all defined properties (not a bad thing either).
39 #--------------------------------------------------------------------------------------------
40 # The path and file used to load user-supplied configuration settings, if any
41 org.onap.appc.bootstrap.file=appc.properties
42 org.onap.appc.bootstrap.path=/opt/openecomp/appc/data/properties,${user.home},.
44 appc.application.name=APPC
47 # The path to search for logging configuration document, and the name of the document
49 org.onap.appc.logging.path=${user.home},etc,../etc,.
50 org.onap.appc.logging.file=logback.xml
55 appc.service.logic.module.name=APPC
56 appc.topology.dg.method=topology-operation-all
57 appc.topology.dg.version=2.0.0